BMW

BMW F87 M2 coilovers – KW V3, ST XTA plus 3 and Nitron R1

Nineteen72 Performance BMW F87 M2 Competition development car

For an F87 M2 that spends most of its time on the road, the KW V3 352200BH gives you two independent damping adjustments and keeps the familiar separate rear spring and damper layout. The ST XTA plus 3 18202208BH makes sense if adjustable front top mounts and separate low- and high-speed compression are already on your shopping list. The Nitron NTR R1 suits an owner who wants a serviceable damper and a single control to work with between sessions. Select the original M2 or M2 Competition before choosing a Nitron configuration.

What changes on the car?

F87 kit Damper controls Hardware and fitment
KW V3 inox 352200BH Independent rebound and compression. Front coilover struts with height-adjustable separate rear springs and dampers. The kit list does not include adjustable front camber plates. Budget for compatible mounts if your alignment target calls for them.
ST XTA plus 3 18202208BH Rebound, low-speed compression and high-speed compression. Front top mounts are included. The rear uses separate springs and dampers. The product page links the ST fitting and adjustment instructions for this article.
Nitron NTR R1 One adjuster changes compression and rebound together. The original N55 M2 listing offers rear-layout and fast-road or track choices. The S55 M2 Competition listing is separate. Confirm its build specification and lead time when enquiring.

Will either kit give the ride height I want?

For the listed rear-wheel-drive M2 and M2 Competition applications, KW specifies 15–40 mm of front lowering for 352200BH. ST specifies 20–40 mm for 18202208BH. Both list 20–45 mm at the rear and permitted axle loads up to 970 kg front and 1,080 kg rear. These are the catalogue ranges for those two references. Actual clearance depends on the wheels, tyres, alignment and starting ride height. Check your vehicle plate and the fitting documents linked on each product.

Choose around the driving you actually do

Daily use with occasional track days. Start by deciding if front camber adjustment is needed. If the standard mount arrangement already suits the car, KW V3 gives separate rebound and compression adjustment without buying a three-way kit. If worn mounts need replacement, include those in both quotes.

Regular track days on a consistent tyre. If you already record tyre pressures, alignment and damper settings, the extra ST compression control gives you another variable to test. Its included front mounts can also change the total cost of achieving your alignment target. Ask your fitter about noise and vibration expectations for your use.

A car built around a specific spring or rear layout. Nitron's R1 uses one combined adjuster. On the N55 listing, a divorced rear keeps the spring separate from the damper. A true rear places the spring on the damper and changes where spring loads enter the car. Confirm the chassis requirements with your installer before ordering that layout. The F87 Nitron R1 and R3 guide covers the options.

What goes into the fitted price?

Compare the kit, front mounts where required, replacement hardware, installation and a four-wheel alignment at the chosen ride height. Tell the fitter about spacers, non-standard wheels and any previous suspension changes. A quote for the parts alone cannot tell you which setup will cost less on the car. Request a fitting and geometry quote with the car's registration, model, current suspension and intended road or track use.

The M2 CS has separate KW applications. Check the KW F87 M2 application list for its references. For other models see our ap, ST and KW coilover comparison.

Reading next

ST XTA plus 3 coilover kit showing front struts with top mounts and separate rear springs and dampers
Volkswagen Golf Mk7 GTI hatchback with a quad-exit exhaust